...leaking. This can happen if you have changed to one of the new high flow air cleaners like K&N. This causes the air/fuel mixture to have too much air and not enough fuel (lean). If you can adjust the ...
...oil leak in one of my fork legs ,is there much work involved in fixinf this It can be as simple as a slight burr or piece of debris caught in your seal. You can try a 3x5 notecard wrapped around your ...
leaking again . when oil was drained got close on 4 gall of petrol/oil out of sump. hello, sounds like you need to set floats in carb, if you have already done that, buy new floats, sounds like one or
...first I thought it was the petcock leaking but it's not. Do you think its something with the carbs please help its a pity its a new a bike Hi, Peterlucia and the usual suspects are: 1. Damaged ...
...gas overflow when ket turned on. will start and run fine. has set over the winter. Probably a stuck float from carb sittting empty...try tapping the carb thats overflowing with screwdriver handle to ...
...oil leaking it is at the back of the engine it runs down to the carbs then heads round the side 2 the right . i have washed the engine so i can get a better look and it is not the head gasket . many ...
Question about 2000 XJR 1300
leaking check for spark leakage in the dark 5. Spark plug gap too close or too wide. 6. Faulty ignition coil, module, and or sensor. 7. Loose, dirty, or corroded ignition module connector at crankcase
...CARB OVERFLOES Hi, Anonymous and the usual suspects are: 1. Damaged or restricted fuel tank venting system. 2. Loose float bowl screws. 3. Damaged float bowl o-ring. 4. improper fuel level in the ...
leaking from your air cleaner is caused by oil carryover from the engine. For whatever reason, the breather system is not separating enough oil mist and air from the piston downstroke. There are cheap
Question about 2002 XJR 1300
...oil in the sump and is pouring out of the carburetor overflow tube Hi, Anonymous and the usual suspects are: 1. Damaged or restricted fuel tank venting system. 2. Loose float bowl screws. 3. Damaged ...
Usually answered in minutes!
19 Questions
11 Questions
19 Questions
10 Questions
11 Questions