...jet $5.00 at a Yam. dealer (don't try to clean it ) & make sure that the idle mixture brass screw on the bottom of the carb is set 3 1/2 turns out from lightly seated. (don't break the tip
...idle screw accordingly but it still dies after letting off the throttle. What should I do to correct this? The motor is a YT125N, there was no listing for this model so I listed the YZ Replace idle ...
yamaha bear tracker 250 I'm trying to get registered so need as much info on it as I can there are alot of models yfm250 (xn ect) the vin is*5y4ag01w030511394* I tryed a decoder but it says that there
atv 250 cc yamaha beartracker timing marks where are the timing marks for setting the valve lash cam sprocket and flywheel..
...idle with choke off replace the $5.00 idle jet with a new one (don't try to clean) & make sure the idle mixture screw is 3 turns out from seated (don't over tighten or will break off tip in ...
...idle mixture adjustment on the bottom of the carb. is set 3 1/2 turns out from seated in (a brass screw ---Don't over tighten & break off the needle tip). Also , be sure the choke is all the way ...
Question about 2004 Warrior Base
...Correct--Not adjustable. Replace the float needle valve with a new one--Yamaha OEM only. If the seat in the carb is dirty or rough, Clean with a Q tip & a little polishing compound like
...adjustment for the clutch on the throttle side of the bike on the motor/trans. it looks like a nut with a slotted screw thru the middle, not sure if its left or right to put more tension on it ...
carburetor adjustment Yamaha Zinger 4 How to adjust the carburetor on zinger 4 Yamaha @ Check this fixya site. http://www.fixya.com/motorcycles/t3086723-1986_yf_60_4_zinger_carb_settings
...yamaha timberwolf 250 it will not start in the cold whether The cold weather may cause your Yamaha Timberwolf to experience hard starting, several months and no use, or a stale fuel supply. Start by ...
Usually answered in minutes!
99 Questions
49 Questions
38 Questions
37 Questions
34 Questions