...car. You set the seat down and push it in toward the back of the car as well as down at the same time to lock it into those clamps. If you look up near the edge of the area where the seat goes you ...
...car told me that I was going to need a fuel pump pretty soon so I'm almost 80-90% sure that's the problem. But the thing is that I don't know whether or not the fuel pump is in the gas tank or not. ...
...into the front clamp by pushing down and back at the same time. It is not easy. You can lift the edge of the seat in the front to be sure you line up the seat bracket with the mount on the ...
seat or center the pad clips on the support abutments. Install the sleeve bolt and tighten to 20 ft. lbs. (27 Nm). Install the cable support bracket (with the cable attached) with the bolt and washer.
...J 35731, or an equivalent spanner wrench, remove the fuel sender lockring. Lift the sender assembly carefully out of the fuel tank. Remove the sender O-ring from the top of the sender and discard. ...
...bracket. Install the service hole cover, then the engage the fuel pump and sending unit connector. Install the rear seat cushion. Start the engine and check carefully for any sign of leakage around ...
...bracket (3).NOTICE: Refer to Fastener Notice in Service Precautions. Install the caliper bolts (1). Tighten the caliper bolts to 31 Nm (23 ft. lbs.) . Remove the wheel nuts securing the rotor to the ...
...seat to the car, and you have no back seat anymore...pull up the rug/insulation and you will see a rounded, rectangular plate held in place by screws-remove those screw, and remove the plate-there is ...
...seat that fit down into a metal bracket on the floor of the car but there is nothing to hold them in there. i just bought the car so there is not clips or anything there that is broken but may be ...
how to remove powered front seat on 1955 Olds 98 undo the 4 bracket bolts
Usually answered in minutes!
1,478 Questions
1,272 Questions
1,097 Questions
1,065 Questions
988 Questions