...hot film meter but nothing changed. On the highway the car drives smooth, but once the car turns on idle it switches to secure mode and I lose all power. To reset it I have to turn off the engine and ...
...car start ok and then once warmed up,it does not idle properly this could be few reasons..First one is if you are having a check engine light is to diagnose it and get the error code and from there ...
car has approx 130k or more miles on it. these engines are cousin of the old 2.8L V-6, and have a tendency that if you don't constantly monitor you coolant level, or the engine is abused, (hot rodded)
...gets to where is touches the red, shut down immediately. When the fan comes on, put your hand behind the fan and observe the temperature of the air coming from the fan. It should feel hot. If it is ...
Question about 2003 Impala
...didnt overheat, and waterpump isnt leaking that i can see. I dont have warm enough air coming out of my inside heater, fan only blowing slightly warm air. is it my waterpump? is it my heatercore? If ...
hot idle. your post really is that, MISFIRE at Cold only idle. i bet all else is theories. tell more get more. get in car, tune key, CEL glows, start car, does CEL go out? if not out, that means there
Question about 1994 Rodeo
...car. we use a $20 IR pyro gun to see if rad core tubes read the same top and bottom if NOT, they are cloggled. 5min work on a hot engine. (harbor fright sells 3 guns all 3 work like MAGIC) is the RAD ...
car) but not their policies. anyone can go to vw.com and to the parts page and see what is sold anyone. just do it. my guess, is you didnt read the FSM yet, on this failure why not? it explains how to
...hot at its normal tempeture driving range and you stop the engine for more then 5 min and then you start the engine again and drive of the problem comes on as the truck wont take off freely and feels ...
Question about 1995 Grand Cherokee
hot? to 180F or more, if not? the thermostat is bad not the freakn PCM.$$$$ As we say 1st things 1st..... nah, it not a bad PCM why (answermen) assume the most expensive parts are bad first. ??????? i
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
