...low. when i push on the gas it will sputter about until 1500 rpms and then runs like a champ. it will go when its sputtering but it seems like it wants to die or the engine is getting choked out for ...
...Engine light on... Just came on yesterday..car is idling about 500 rpms then normal and when put into gear the rpms seem to sputter like the car can't keep up. Your low idle, needs to be ajusted up ...
...low, the engine rpms drop from 1,000 to dead. The only exception is that I have no time to rev the engine to keep the rpms from dropping when in forward low. I thought it might be a MAF, but I now ...
Question about 1997 Mountaineer
...sputters and backfires when climbing a hill When the rpms are low and there is a load on the engine like pulling a hill it will sputter and backfire but it goes down the road just fine otherwise. EGR ...
...engine light came on and my car started sputtering. it sputters at idle and low rpms. at higher rpms it sounds/feels normal. if i keep the car at a constant speed the engine does it more, and twice ...
Question about 1992 Lumina APV
car sputters and dies, its difficult to restart. It turns over but doesnt want to fire for a few minutes, sometimes at all for a cpl hours. Any ideas?? Just replaced spider gears in transmission month
...engine light will come on and off from time to time. I will also feel the sputter while at a stop, which I feel through the car, if I shift the car into neutral the shutter is less evident. Any ...
Question about 2003 Spectra
...a can of carb cleaner...brake cleaner...whatevers clever with the car running spray it over vac maf sensor...until you hear the engine bog down. now you found ur vac leak or anything else and
Question about 2006 Forenza
...for 100 years is never getting a tune up. nothing beats this cause, due to driver driving car till it quits or sputters. if low on cash? try new spark plugs... gapping them to spec, not
Question about 2006 Forenza
...75 mph and sputters and chugs at low speeds and rpms. help remove them, try looking into the engine, take out the gunk around the spout, then fire the rod into the section frame. this should fix ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
