Questions & Answers for: car amplifier dc output

DC on the outputs) causes the amp to go into protect mode. In your amp, you may have shorted output transistors, open emitter resistors and possibly a problem with the protection circuit. To get up to

Amp no longer turning on My Legacy LA1030 amp has stopped working. The power light nolonger comes on however there is a constant DC voltage on the speaker outputs even with no input signal. What do ...

car power amp, JVC KS-A82. It's a 2ch/1ch unit. The guy that is selling it says it's 200 watts. I don't believe that it is, but I do not want to pay some website $10.00 to find out. Defiantely not 200

...DC current on the amp output terminals. Disconnect the sub and test the output with a multimeter. If there's DC there, most likely the amp is shorted internally and needs repair. Hope this

Amplifier Recommended Use Car Width 8.7 in Depth 9.1 in Height 2.2 in Weight 6.0 lbs Dimensions (WxDxH) / Weight Amplifier : 8.7 in x 9.1 in x 2.2 in / 6.0 lbs Enclosure Color Black Enclosure Material

...AMPLIFIER, IT MAY BE OUTPUTTING DC WHICH WILL EVENTUALLY BURN THE VOICECOIL OUT. MOST TIMES AMPLIFIERS ARE DESIGNED WITH PROTECTION CIRCUITRY TO DETECT THIS CONDITION. A FEW RARE AMPLIFIERS WILL ...

...amplifier and they have 55v DC current at the output , so blow speakers. what i can do? THIS IS CAUSED BY SHORTED OUTPUT TRANSISTORS AND/OR DRIVER TRANSISTORS WITHIN THE AMPLIFIER AND THE PROTECTION ...

...output mosfet that is ocillating cause DC to leak onto the speaker output causing it to flip into protect. please advise thanks,ben My amplifier is out of safety mode but specker pops and ...

peavey 3400 dc on output a if start up output A 3 volt after 6 min output is OK Check for swolen caps.

...amplifier have a DC bias voltage that is one half of the battery voltage. When using a DMM, each of the audio output channel circuits will measure approximately 6.5V DC. The audio being played on the ...