Question about P3314 14" Gas Chain Saw 2.0 Cuin 33CC 2 Cycl
...like the check valve in the cap is stiffening and not flexing. Best bet is to buy a new cap. Most caps like that sell for less than
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
I AM UNABLE TO GET THE FUEL CAP TO SCREW DOWN TIGHT ENOUGH TO PREVENT LEAKING. REMOVING IT TAKES A SCREWDRIVER USED AS A LEVER OR A PAIR OF CHANNEL LOCKS. WHY DID THE FUEL CAP SUDDENLY BECOME TOO ...
Question about Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
gas cap is almost impossible to get on and off. Hi Is this the original cap ? If it is check the screwing both on the cap and on the chainsaw and look for some bends or defects that might cause it to ...
spool cap struck i tried both directions to get the end off to respool with string and it is stuck what do i do Well you are going to have to cut off the cap off the get to the bolt head inside the ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
I have a hard time getting the gas cap to go back on once I have filled the tank. I have tried lining up the notches before turning, I have tried to push it into place before turning the cap. It doesn
Question about Pro 16-Inch 38 cc Anti-Vibration Chainsaw #PP3516AVX
Darned gas cap will NOT go back on ~? Re: PoulanPro 16'' 40cc. Anybody know why the $%^&* gas cap will NOT fit into the gas fill pipe...and how to solve? Plastic body & plastic cap. I wonder ...
improperly cast. Make sure the 'O' ring seal is at the outside end of the cap. Try swapping the two caps to see if one works better than the other. Good luck
...on same way, its almost impossible to put on,any suggestions will be helpful. i hpoe Try swapping caps with the oil tank--if it fits better, buy a new cap as it was probably improperly molded. If
...fit. Rubber seal on top of cap holds the gas in.....Easy to do. Massive problem with gas and oil caps of Poulan chain saws. Cannot remove or screw caps due to inadequate material. It ...
PP4018 gas cap won't come off. #PP4018 gasoline cap is swollen. BOIL UR KETTLE, THEN SLOWLY TIP IT OVER THE CAP.... IT WILL ENLARGE THE CAP MORE,,, THEN USE A RAG OR OPENING TOOL.. SHLD WORK ...
Usually answered in minutes!
96 Questions
36 Questions