Question about EC12 Portable Electric 2hp Air Compressor, Oil Lubricated
...safety, unplug the electric power to the unit and release any pressure in the tanks. Then unscrew the cap of the non-return valve (between the compressor and the tanks). Inside you should find a ...
Question about EC12 Portable Electric 2hp Air Compressor, Oil Lubricated
...safety valve goes off and i lose all pressure what is the working pressure bud Are you sure its the safety valve? Mine was doing this too but if you check where the air is coming from I found it was ...
Question about EC12 Portable Electric 2hp Air Compressor, Oil Lubricated
...cap was located. You stated it was located under the relief/safety valve but it's not part of the valve correct? Is it part of the manifold attached to the bottom/backside of the switch? Although the ...
Question about EC12 Portable Electric 2hp Air Compressor, Oil Lubricated
...safety valve, item #64 on the parts diagram, is opening at 120lbs and not shutting until the tank is drained. If that is the case you most likely have a bad safety valve, part #881-493 which is ...
Question about EC12 Portable Electric 2hp Air Compressor, Oil Lubricated
...safety. Remove the small hose (1/4) at the check valve and verify that air is leaking from valve. If leaking remove cap from checkvalve and look at inner plastic valve for cracks. Replace as needed ...
Question about EC12 Portable Electric 2hp Air Compressor, Oil Lubricated
...valve is the chrome part with a hex cap adjacent to the upper tank. Remove the cap and make sure the piston moves freely. Slight resistance is ok, but if it sticks your compressor willl continually ...
Question about EC12 Portable Electric 2hp Air Compressor, Oil Lubricated
...valve. If cap test good, remove rear cover and manually turn fan. If frozen of hard to turn, drain oil and remove cylinder where it is attached to body and pull it off. From here you will be able to ...
...turn on the TV then? Is there any sort of reset that I can use? or what must be replace? You can try resetting it by unplug it for about an hour. If it still does not work, then the first place to ...
Question about 32LD8700 32 in. LCD Television
...valve. Turn in or out several turns till head of nail is correct when bump firing then lock the nut. The safety foot fits rather loose on the gun and should still work ok but can get so loose that it ...
Question about 32LD8700 32 in. LCD Television
...should blow down for a short period then stop. If it dont stop your tank check valve is bad. relief valve is bad (most probable). ...
Usually answered in minutes!
35 Questions
1 Questions
1 Questions