Questions & Answers for: Jeep Grand Cherokee cap and rotor

no fire - new coil distr cap and rotor power to no fire - new coil, distr cap, and rotor. power to coil ok getting no fire from plugs at all check the crankshaft sensor

...cap and rotor - now it will not start? Did verify the firing and that all were plugged in correctly. If the wires are in the correct order, also make sure that you used the correct starting point, ...

...cap and rotor button for damage. If that all checks out? replace crank sensor I have same problem, if you have alot of miles on your jeep, check ignition timing, first, could have jumped a tooth on a ...

...cap. Note the position of the rotor in relation to the base. Scribe a mark on the base of the distributor and on the engine to facilitate reinstallation. The distributor must be bright to Top Dead ...

...cap and rotor runs terrible had it towed is it possible that a fuel kill switch has been compromised if so where is it? There is no fuel kill switch on any jeep/chrysler product. Is it possible that ...

cap and rotor still nothing Take the cap off and watch the rotor turn. If the shaft broke and the rotor was not turning, you would not get any spark. Could be the engine ground also came off, so there

...start Please change the rotor and cap before you go any further. The rotor tip can be worn which can prevent charge from getting to the plug wire. The contacts inside the cap could also be

cap and rotor to see the connections have not turned black which means no connections to each spark plug when the rotor goes around inside the distributor cap and if you see the connections inside the

...wires and put on new cap in same order or remove cap put new one on and remove wires one at a time and put on new cap. Replace rotor too they ware togetherchargerhp Level 1 457 Solutions42 ...

...same position as the screws on side remove wires and put on new cap in same order or remove cap put new one on and remove wires one at a time and put on new cap. Replace rotor too they ware ...