Questions & Answers for: Chevrolet Blazer cap and rotor

...cap and rotor? I recently broke down with no heat and my gage running in the red. I had to have the intake manifold gasket replaced, radiator flushed and was also told that they replaced the ...

Ad

Question about 2001 Blazer

2 Answers

CAP AND ROTOR WHAT DOES A BAD CAP AND ROTOR LOOK LIKE on the cap the contact points inside will look coroded--not square edges and burnt spots where the rotor fires against,the rotor will look burnt ...

Ad

...cap and rotor that's where your problem may be. The after market cap and rotor is not as heavy as the OEM and when the two screws that hold down the cap to the distributor is torqued to high,it warps ...

...rotor or cap and rotor?and what engine size v6? A bad ground burned the coil up. Plastic smoked out the bottom. After a new coil, computer, control mod, pickup coil, cap,rotor,plugs,wires. What else ...

...cap and rotor , then dust shield and then the two screws holding it down. install in the reverse! good luck It is in the distributor on the left side under the rotor and bolted on the dist. plate. It ...

...cap and rotor on a 2000 chevy blazer 4.3ltre v-6 Disconnect the wires and take pictures with cell phone for reference to ensure you don't cross them when reinstalling the new distributor cap. Remove ...

Question about 2001 Blazer

1 Answer

...Cap on the rotor and in the distributor, 2001 Chev Blazer Xtreme 4.3 v6. I had misfires,and then it stopped running.pulled the cap,and rotor off and found extreme corrosion,burnt tips on the rotor in ...

...cap and rotor. I dont know what size engine you have, but it's pretty much the same. Mark your wires with a piece of tape and write a number on each one. When you remove the wire from the cap, ONE AT ...

...cap & rotor. i didnt realize the new hold down bolts for the cap were taped to the insideso when i started itthe rotor and cap got damaged so i replaced them and the car still wont start. it ...

...cap and rotor. These are wear items and require periodic replacement. Given it abruptly quit, the spring contact of the rotor has likely fractured. Most likely the points are gapped wrong or have ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...