Questions & Answers for: cap and rotor Cars & Trucks

Question about 2001 Blazer

2 Answers

CAP AND ROTOR WHAT DOES A BAD CAP AND ROTOR LOOK LIKE on the cap the contact points inside will look coroded--not square edges and burnt spots where the rotor fires against,the rotor will look burnt ...

Ad

...rotor cap OFF. When you see the pressure build...you're on the compression stroke. The rotor cap should be at the #1 cylinder firing position...simply re-install the rotor cap at this time - noting ...

Ad

Question about 1994 Jetta

1 Answer

cap and rotor On the 2.0L motor, pop off the 2 clips on the distributor, holding the cap on, move the cap out of the way. Pull the rotor off the shaft. And press on the new one. Then remove the center

Question about 1994 Jetta

1 Answer

...ORIGINAL POSITION. WHEN ALL PLUGS WIRES ON DISTRIBUTOR CAP BEEN NUMBER.REMOVE ALL PLUG WIRES ON CAP.THEN REMOVE THE DISTRIBUTOR CAP.THEN MARK ROTOR POSITION WITH SHARPIE MARKER THEN REMOVE THE

...cap/rotor.maybe pickup coil but probably not.pop off the cap look at the brush/contact between rotor and cap, if messy lightly pull brush from cap and also cap use fine sandpaper to clean them, then ...

...Cap & Rotor - Removal & InstallationNOTEThe 1996-00 3.3L engines were equipped with a distributor.Disconnect the negative battery cable.If the distributor cap is to be replaced, mark the ...

Question about 2005 Sorento

1 Answer

cap? The rotor is stuck on and I am having trouble removing it. no need to remove cap. just use a rubber mallet or a hammer and a block of wood to loosen the rotor but not damage it if it is stuck or

out. When rotor spins inside cap a spark jumps from the rotor end to the post, to the plug wire ,to the spark plug.The space between the rotor and post in the cap where the spark jumps, is the air gap

...cap and rotor Label or mark the wires before removing the cap, this is very important. Make sure the new cap goes on just like the old cap came off. The rotor is under the cap and should slide off by ...

...wires Tried new cap rotor plug wire plugs brought #1 to top dead center both valves close an rotor points to # 1 plug any ideas carbon tracks around the rotor button, rotor button slipping on the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...