Questions & Answers for: Mazda cap and rotor

...just fitted a new rotor arm and distributor cap to my mazda 2.5 v6 mx6. now it wont start up. i have put my old rotor arm and cap back on but the problem is still there. ignition coil may be ...

Ad

...cap,a new rotor button, new plug wires ,new spark plugs and 2 new coils, the coils are firing through to the rotor button inside the distibuter cap,the engine block does have a perfect ground,but i ...

Ad

...cap back on, and then put #1 at the rotor tip, and remember what direction the rotor spins ? now put your spark plug wires on the cap to match the "firing order" The firing order is 1-3-4-2 with the ...

cap,rotor ,wires good power to coil and module If there is no spark to the plugs, but good cap, rotor and wires; then if the there is good power to coil and module, then the module or coil must be bad

Question about 1990 626

1 Answer

...cap and rotor and this will hopefully solve the issue. Best bet is to replace the cap and rotor about 30$ total. This will give you a new rubber seat and water should bot make its way in. Let me know ...

Question about 1985 RX-7

1 Answer

...Cap Rotor and NGK wires and plugs. Has been good enough for factory race teams also. An issue with most aftermarket rotors is that they do not fit properly and can cause changes in timing and worse ...

Question about 1999 Millenia

2 Answers

cap and rotor, and dry out the inside of each plug wire boot before you transfer each wire from the old cap to the new cap. Use dialectic grease ( it comes in small tubes) inside each spark plug boot.

Question about 1999 Millenia

3 Answers

...cap off and bump the started to see which direction the rotor turns in and you can work out the firing order from that. Standing in front of the vehicle looking into the engine bay, the cylinders are ...

...dist but not at the plugs. Cap and rotor look good, just not sure why spark doesn't go throug h dist if you have spark to the cap but not out of the cap you have 2 problems. the cap and the

...the engine , no 1 cylinder is on TDC on compression stroke , distributor rotor pointing to number 1 post on cap, number 3 is the next post on cap in direction of rotor rotation , followed by 4 then

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 Mazda 6
2004 Mazda 6

738 Questions

2000 Mazda MPV
2000 Mazda MPV

692 Questions

1999 Mazda 626
1999 Mazda 626

544 Questions

2001 Mazda Tribute
2001 Mazda Tribute

609 Questions

2002 Mazda Tribute
2002 Mazda Tribute

615 Questions

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...