cam shaft seal.. could oil be coming from that one...i do know that the leak is down low somwhere This sounds like the crank seal, the engine doesnt have to be removed, in order to get to seal is like
...cam shaft seal i have access to both i can not get the cam seal out any ideas on to get it out ? and also i can not remove sprocket on the crank shaft to get to the seal any ideas on how to get that ...
Question about 1994 Tracker
...cam shaft seal in Geo Tracker,1.6 liter engine replace front cam shaft seal,and timming belt,and align timming marks. remove tbelt (lots of steps see link) remove front cog on cable( 8v head is diffr ...
Question about 1995 Tacoma
...cam and crank shafts. I read a forum that stated it being a bad idea to cut and pry theses seals out as ddescribed in the Hayne repair manual. Do i really need to remove the whole shaft to do this ...
...cam shaft talked to dealer and it got me no where need to know what that part is and what is does so i can stop the leak could be the cam cover case, or the cam shaft bearing seal leaking. cam cover ...
...Cam shaft ? which would cause this problem yes there is a seal on the cam shaft behind the water pump pully undo that bolt you have to undo the cam shaft to get to it .dont drop the lifters 19 nm for ...
Question about 2004 Highlander
...dry now no leaks do you think cam may have a ridge on them and cut new seal ? The seals never have been change I would for high miles. Also would sand cam shaft with fine grit sand paper. 1000
Question about 2004 Highlander
...cam 2 door - Do I need to remove the gearbox to replace the output shaft seal or can it be done by removing the shaft and putting a new seal in? You should be able to change the shaft seal just by ...
Question about 2004 Highlander
What would cause the back Cam Shaft Seal to push back out after replacing the seal in my 1999 Chrysler Sebring Convertible Jxi/ V6? not properly sealed --wrong seal --debris --cam walk
Question about 2004 Highlander
...cant imagine i messed something up cam seal that doesnt have anything to cause a p00010 code vvt --oil sludge cam --crank shaft position sensor possible failing where did a cam seal come from
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
