Questions & Answers for: Dodge Durango cam sensor

the distrubutor cap but i took it off it wasnt there can u help me? The cam sensor should be in the distributer, not in the cap. They used to call them pickup coils, but now they call them Cam sensors

...cam sensor can cause it to flag a crank code. You might end up replacing the crank and the cam sensors. i had exactly the same problem but my durango would heat up when i get home.. 20 minutes away ...

were helpful to me and my fix was 3 screws and < $300.00. Your cam sensor my be bad. I just recently had tje same problem withh my 02 durangoi replaced the cam sensor & havent had a problem since.

i change my cam sensor crank sensor in my 2001 dodge durango and it will not run for more than 10 mins change your coil pack. I guess if you change cam & crank sensor it's a 4.7L.Does it restart

...cam positioning sensor in 2003 4.7 dodge durago how do i replace a cam positioning sensor in a 2003 4.7 dodge durango or where can i find a site that will let me print off the directions? Answer ...

tranmission Eratic shifting? Change the throttle position sensor (TSP) first, then the Cam position sensor (both around $24.00) - easy fix Hi You need to be a bit more specific

...sensor and cam sensor i changed them. I am having a problem my durango has a 4.7 and im having a hard time starting it. It takes a few cranks before it starts then it runs good untill i stop at a red ...

installed new tps sensor ran good a couple days then installed new cam position sensor now code reads no cam signal at pcm what should i do know Recheck the cam sensor and the wires that connect to it

cam sensor location If you have the 2.5L V-6 engine, the cam position sensor isn't immediately visible, as it is integral to the distributor. If you have one of the 4 cylinder engines, it's located at

cam sensors Complete tune up Coil Temp sensor Up-down o2sensors Computer Still says loss of crank- cam sensors Could be in the wiring, then, for those 2 sensors. I think they would both share the same