Questions & Answers for: Dodge Caravan cam sensor

cam/crank correlation sensor!! coil/wires/ plugs are new. I am getting some red fire but no blue fire.HELP Is there a sensor between these two or is it the computer, dont think so or the scanner would

...cam shaft sensor on this motor,, 1993 3.3 dodge caravan it is on top of engine at the back were the cam-shaft is hope i have helped you The Cam Sensor senses a slot on the camshaft gear (part of the ...

cam sensor new coil pack new flexplate still no spark, scannner show sync problem, any ideas If you have replace new cam sensor with no sparks and the coil are good putting out 12 volt, my guess would

cam shaft sensor back off.Look in at the cam,and have someone crank the engine over and over,and see if the cam is turning.If the cam is turning,this will tell you the timing chain is not broke.But it

cam sensor error changed sensor turns over but won't start. Had a cam sensor error code a few days ago. Changed cam sensor and still same problem. You may have jumped time,since the cam sensor did not

...cam pos sensor, no fix. I don't seem to be getting fire to the coil pack. any tips on testing or repairing? does it have a crankshaft sensor? My experience is cam position adjusts timing, crankshaft ...

No signal from crank or cam sensor If you are not getting a signal form your crank sensor or your cam sensor they are bad and need to be replaced.

...cam/crank sensor. The crank sensor was changed recently but the cam sensor was never changed. to keep the vehicle running I periodically disconnected the battery terminals and this seemed to reset ...

...cam sensor caravan 1998 3.0? I have error P0340 The cam sensor on the 3.0 is in the bottom of the distributor. You may have to replace the distributor. I'm not sure this sensor is easily

cam and crank sensor go in and out of sink no start timing chain and gears have been replaced and both sensors no codes Cam and crank sensors both have to be gapped. A couple pieces of masking tape on