...cam sensor it runs?what that mean is that most likely your sensor is bad..reason for that is when your cam sensor is out you unplug it...it will run because it forces the computer to get a ...
Cam sensor causing other probelems I have a 2005 dodge neon. Its over 100,000 miles now. The engine light has been coming on. Some days it drives fine.. Other days it jerks/sputters when i try to go ...
...signal at pcm, has 5 volt supply at cam sensor and ground at cam sensor. I thought it would start with the cam sensor unplugged, it would just have a long crank time. crankshaft sensor had same ...
Question about 1996 Caravan
cam sensor error changed sensor turns over but won't start. Had a cam sensor error code a few days ago. Changed cam sensor and still same problem. You may have jumped time,since the cam sensor did not
...sensor 0344 cam position sensor intermittent 0340 cam position sensor failure I would replace the cam position sensor from the codes you provided. The knock sensor would most likely be related to the ...
cam sensor unplugged because the ecm sees the camshafts aren't in time with the crankshaft. With the cam sensor unplugged it doesn't know its out of time and it starts.' Does it means that
...cam sensor, bought a new part and bolted it up, i still have the code 0344, misfire detected... also new plugs and wires. any alignment required for sensor? i removed the old one and bolted new one.. ...
Question about 2000 Neon
...cam shaft sensor is unplugged i have check the timing over and over, replaced the cam sensor and crank sensor, replace the wiring harness and check the cam shaft magnet! And i have checked the cam ...
installed new tps sensor ran good a couple days then installed new cam position sensor now code reads no cam signal at pcm what should i do know Recheck the cam sensor and the wires that connect to it
...cam sensor unplugged will also continue to run after plugging the cam sensor in but if you shut it off it wont start with the cam sensor plugged in you have to unplug it again to start? Replace .cam ...
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions