...cam sensor. so the cam and crank sensors were replaced. tried to start the car still wouldnt turn over. unpluged the cam sensor and tried to start it again and it WORKS. so right now my c ar is ...
...cam position sensor circuit malfunction, but it is not the cam sensor. Where can I look for the problem? did u replace the cam sensor a code like that tells u what it is should check the wiring ...
...cam sensor 3.5L suspect cam and crank sensor out of sync (according to scan tool) swapped pcm starts other car fine. timing belt and cam sprocket alignment procedure complete. however left sprocket ...
...cam posostion sensor ? p1391 is intermitant loss of signal from crank sensor and cam sensor--change sensors!! change cam sensor first. good luck!! then try it, if still same way. change crank
...Cam sensor? or Crank sensor? I know that the generic definition of DTC P0340 is "No cam signal at PCM" however, a crank sensor can also be the cause of this code. A cam sensor normally will not cause ...
...CAM sensor error. Got it replaced but error still there. Got Fuel filter and the sensor on the engine Oil cae( where the spark plugs are) changed. Checked and replaced the timing belt. But still the ...
Question about 2007 PT Cruiser Touring Hatchback
...cam shaft position sensor and magnet, crankshaft position sensor, and engine coolant temp sensor on. first after putting the belt on it came up engine coolant temp sensor changed it, still showing up ...
Question about 2007 PT Cruiser Touring Hatchback
...cam sensor with a aft market sensor my fuel gauge started reading wrong, and it didn't fix my problem so i replaced the cam sensor with a factory sensor it fix my running problem but the fuel gauge ...
Question about 2005 PT Cruiser
...in the diagnostic problem cam sensor change cam and crankshaft sensor and still in the diagnostic problem cam sensor just remove the battery terminals for a while firstly removing negative ...
...cam shaft sensor bad? Code 16 is for a problem where the correlation between the crank sensor and the cam sensor for bank one is off. So yes it could be the cam sensor or the timing belt. If ...
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions