...properly. Possible Causes are: Loose cam sensor Bad connections between the cam sensor and the ECM Cam sensor is defective Camshaft Interrupter Magnet that is the code for low coolant
...cam sensor located Ive searched high and low , its on a 1992 Buick Century 3.3. My injector are not opening is it the cam sensor, or crank position sensor I have the same auto and on that engine the ...
cam chaft sensor,crank shaft sensor,massive air flow sensor,starter,spark plugs,coil pack,computer,fuel filter,fuel pump, Check ecm for number 1228253. If it has this one in it you will have a cutting
...cam sensor, so i did. now the check engine light is still on and it still say i need a new cam sensor. what should i do... it thought i should get new wiring for the sensor but i would like some one ...
...Cam sensor error. Where is this located and how hard is it to fix. The cam sensor is located on the right side of the engine near the end of the cam shaft. Remove the retaining bolt and plug then ...
...cam sensor. Replaced sensor but still setting code. I suspect magnet on cam sprocket. Only 85K miles but 20+ years old. Sometimes initially hard to start. Will cough once then start. This will ...
Question about 1989 LeSabre
...cam sensor in my 1989 Lesabre. how do i reset the service engine soon light? That one is old enough that you should be able to disconnect the battery for a couple of minutes to reset the computer. I ...
Question about 1989 LeSabre
...cam sensor in my 1989 Buick Lesabre. How do I get the service engine soon light reset? That one is old enough that you should be able to disconnect the battery for a couple of minutes to reset the ...
Question about 2000 Regal
...cam sensor and IGM code still comes back I changed the cam sensor and the IGM but the code still came back what else can it be problems associated with the cam sensor are ---insecure ...
...CAM SENSOR If this is a 3.1L or 3.4L you must get the power steering pump out of your way the cam sensor is located on top of engine block under the p/s pump. Remove bolt with 10mm socket and ...
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions