Questions & Answers for: Oldsmobile Alero cam postion sensor

...the camshaft senor in my daughters car this is one thing i havent done before the cam shaft sensor will belocated in the rear of the engine block it will have a weatherproof 2 or 3 wire

03 olds alero 2.4 temp drop to -30 , car plug in , in car port,turned over slow so hooked up jumper cables and car turns over fairly fast but not even trying to fire? with blanket and 1500 heater over

cam position sensor. Need to know if I can replace it without taking a whole lot apart? It's not that hard to replaced, and can be done with common tools.  3.4 camshaft sensor removal: Remove the

...filter. No OBD II faults. Any ideas? Start with the ignition controll module, it's located under the coil pack and can be tested at most parts stores. also could be the crank or cam postion

...cam sensor and now I've been told I need to change the gas regulator but the security light blinks when I turn the car on. Your going to have to get the codes from the theft deterrent module.This is ...

...the cam sensor is located According to Haynes Manual, the cam position sensor is located in the timing chain cover which is above the crankshaft on the left side of the timing cover. Good luck ...

...cam position sensor located on a 99 oldsmobile alero, how easy is it to install? camshaft position sensor location on the V6 engine located at the front of the engine block below the power steering ...

...cam psition sensor, but it does not have a cps, then if it does not have a cps what could be the problem Cam position signal is generated by the ICM which sends it to the ECM (engine computer) your ...

sensor or cam sensor would cause those exact symptoms-have the computer scanned to see if there are any pending codes (done free at most commercial auto parts stores). If there are, write the code (s)

...to do . trying to replace the cps but cant seem to locate it Check that the cam shaft is turning as it may have broken a timing belt. Run fault codes to check for cam/crank position sensor