Questions & Answers for: Nissan Maxima cam postion sensor

...cam sensor cause a hard start i change my starter this week after it went bad due to a hard starting problem i had. but i was told it could be the cam sensor that cause it to go bad in the 1st place ...

...postion sensor on bank 2 camshaft postion sensor on bank 2 how to replace Should just be a simple remove and replace. Engine off disconnect sensor, remove sensor, install new and good to go (assuming ...

...cam timing sensor the engine runs smooth. has had new chains fitted. was very rattly. was missing sometimes before chains replaced. have checked coils. all ok. found only running on 3 cylinders with ...

...TPS sensor can you get access to a scan tool to see if there is any codes set and to see if you are getting a TPS(Throttle Postion Sensor) signal,also could be a faulty MAF sensor. MAF=Mass Air ...

...off (otherwise they will charge $600). I also read you can get an aftermarket coil at Autozone. crank postion and cam postion sensors you have 2 bad coils do not use after market buy new from ...

...cam and crank sensors, particularly the crank sensor. And, maybe swap out a computer ito see if that rectifies the problem, since the computer controls the injector pulse assuming it gets a signal ...

...cam sensor is held into the head with a 10mm bolt, has one wireing connector with 3 wires in it. the sensor is sort of round with a leg off one side for the bolt the secure. may need to remove the ...

...one you found in the front you have a cam sensor on the top and underneath the crank pulley is the crankshaft postion sensor the rear one is on the side of the bell housing in the front of the ...

how to replace cam sensor on b1 Here's a link on removing your cam sensor. Replacing Camshaft position sensor Nissan Maxima 2004

...cam sensors because i replaced crank sensor and it has a hard start but it will start Hi Maliasa replacing sensors is not the answer cam sensors will not prevent starting get someone to plug in your ...