Questions & Answers for: Ford F-350 Super Duty cam postion sensor

4x4 low light on and also (ABS) light on too cant get to switch to 2wheel drive its stock, and i got another problem with the ABS light still on. I've tried sensors and the fuses but no luck. can ...

Trouble code p2452 ,p040d The first code is for the Diesel particulate filter sensor and the second is for a high temperature on the EGR temperature sensor. Your truck may need a new Air filter and I ...

what causes the front brakes to pulsate on a ford f-350 super duty the front brakes pulsate when I apply the brake at speeds over 10 MPH even if I apply lightly. New rotors new calipers new pads have ...

...well be a cam sensor. Located on the front of the engine it is held in by one cap screw and is easy to replace. Most of those were recalled and replaced by Ford but they do go bad from time to

...intake crank no start I drove it all day no problem ,had it on the interstate for about 2-3 hours, came home and shut it off in the drive went out an hour or so later and it cranks but no start, so

how to repair 2008 ford F-350 diesel showing code P2033 code p2033 refers to exhaust gas temperature (EGT) sensor 2 bank 1 circuit high === causes wiring short to ground --EGT sensor . check the ...

...cam shaft sensor and pig tail wiring connector were restored.I replaced both but can not clear the code, the truck run's great starts good, year is 2010 Sometimes a battery disconnect will overnight ...

...cam shaft postion sensor and what does it do anjd is nessaceary? it tells the computer were cylinder 1 is in order to allow the ignition and fuel injectors to fire correctly so the engine is in sync, ...

The idle on my 2004 f-350 5.4l just today has been? racing at high rpms and the transmission is taking longer to shift. What could be causing this problem? Check TPS sensor or IAC sensor.