Questions & Answers for: Ford F-350 cam postion sensor

Question about 2005 F 350 Super Duty

2 Answers

...cam sensor? Under the ft driver side bumper locate power steer line and pump above line is sensor in block has two wire plug one bolt 8mm. long socket with short ext 1/4" drive should do it. has ...

Ad

...cam sensor. If that doesnt work, check Injection Control Pressure Sensor, Fuel Filter, Injection Pressure Regulator, HPOP, and scan the computer for shits and giggles with a snap on machine to make ...

Ad

Question about 1997 F350 Crew Cab

2 Answers

...cam sensor on the front of the motor. Most engines call this the crank sensor but on this engine you have to look it up as a cam sensor. Had all these same problem - Replace oil pump truck runs great ...

Question about 2005 F 350 Super Duty

1 Answer

...cam sensor behind the hormonic balancer. the fuel pump is working. That's the crankshaft sensor by the harmonic balancer. Is it a V-10 or what engine? It could be the cam sensor which is located on ...

Question about 2001 F350 Super Duty SuperCab

1 Answer

...Frist start up for day no mater if day is 30 out side or 80 out side New injectors installed New Cam sen postioner installed New Duel 1000/800 batters New Battery wires and ends New Fuel Filter

Question about 1999 F350 Regular Cab

1 Answer

...cam sensor location Right below the water pump on the passenger side. http://rides.webshots.com/photo/1035102020028475244oPQQEZ The sensor was a recall item so you might get the dealer to change it ...

Question about 1999 F350 Regular Cab

1 Answer

...postion sensor was bad replaced still won't fire the machine wont tell you that the sensor is bad... it tells you its getting a bad reading from the sensor. which means it could a problem in the ...

Question about 2006 F 350 Super Duty

1 Answer

...a diesel engine if you are its the cam position sensor, its on the lower front on the driver side,they are common symptoms it warms up and you stall, just replace it ,make sure connections are

Question about 1999 F350 Regular Cab

1 Answer

...cam sensor.....Low coolant level will cause the same failure ...If coolant isn't touching sensor which is located in the coolant reservoir...when coolant sloshes up and down while driving it will ...

...cam and crank sensor replaced.ohms from ecm to sensors good, signals on lab scope clean need known good pattern and how to hook up to check if the sync is there If u are getting white smoke and a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...