postion sencor,and the cam sencor and added new grounds. I don't know if this will help but I had the same problem on a 1993 Intrepid. It turned out that the problem was a broken wire at the connector
...POSTION FROM THE START POSITION. THANKS TB You checked crank sensor & cam sensor right? If all that checks out good, I'd be tempted to remove battery cables, then remove connector on PCM, and ...
...for about 1-2 miles. P1391 came up on the scan tool. What could my problem be? I recently changed the cam sensor and crank sensor. P1391 code is intermittent failure. could be thottle postion ...
...cam postion senor, but I have a 97 Intrepid sport 3.5L. Sounds the same though, and I went through all that too. They are expensive, so I picked up a used one and it worked. They have to be gapped ...
...cam positioning sensor on my 2003 2.7 dodge intrepid Quick fix. No worries. There is 1 bolt and one wire connector for the camshaft postioning sensor. The sensor is located on the front of the block ...
the PCM as required Ive found these cars have timing chain problems and also cam gear problems, the gear move off postion cause the code, you would need to first make sure the timing marks all line up
Question about 2000 Intrepid
...cam or crank sensors have failed or the computer does not see them for some other reason. first make sure that your timing belt is spinning the camshafts, then see if you are getting juice to the two ...
Usually answered in minutes!
1,166 Questions
867 Questions
924 Questions
766 Questions
627 Questions