Questions & Answers for: Plymouth cam postion sensor

...cam sensor cam sensor fires the injectors to synchronise injector pulsing with the spark at the spark plugs.. U need to probably change the crankshaft sensor (around the crank pulley) as the crank ...

Ad

Question about 1997 Breeze

1 Answer

...cam or sensor Could you explain how it could be a bad cam or cam sensor? Check this out.. The cam sensor wires and the Ignition coil wires CAN interchange.. If you reverse them.. It'll blow the ecm.. ...

Ad

Question about 1998 Neon

2 Answers

cam sensor and computer put in both used. Shop did not put a wiring harness for the cam sensor. New spark plugs,wires, and coil pack. Car will start run gets warmed up and stalls, but not all the time

...cam sensor what else could it be have you checked timing belt?it may be broken..engine controller must see signals from both cam and crank sensors to close shutdown relay to send power to coil..if ...

Question about 1999 Neon

1 Answer

...sensor,cam sensor,pcm,wired cam and crank sensor direct to pcm,replaced coil, plugs and wiresand air intake temp sensor...also replaced plug ends to crank and cam sensors sounds ike it could be the ...

Question about 1998 Voyager

1 Answer

i have a 1998 plymouth voyager it stalled when driving will not start at all TRY THE PRESSURE RELAY FOR THE FUEL PUMP ,OR THROTTLE POSTION SENSOR ,OR THE FUEL FILTER

Question about 1998 Breeze

1 Answer

...postion sensor on a 1998 plymouthbreeze how to If you have the 2.0 SOHC the sensor will be on the right side(driver side) of the valve cover just underneath all those wires from the wire harness and ...

Question about 1998 Breeze

1 Answer

...postion sensor located on a 1997 plymouth breeze The cam sensor is located on the drivers side end of the cylinder head. It is a flat, black piece of plastic approx. 2 inches square. It has 4 bolts ...

...cam shaft postion sensors. replaced the starter. fuel pump is fine. injectors are pulsating. car occasionally backfires. timing is lined up and all battery and ground connections are good. what could ...

I changed my coil pack and my crank shaft sensor but my 99 Plymouth grand voyager will not start how do i change the cam shaft sensor check cam sensor or pickup coil in distributor.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...