Questions & Answers for: Lincoln cam postion sensor

Question about 1996 Town Car

1 Answer

...cranking vehicle it should go off then after about 10 seconds of cranking it should come back on while cranking,if it does not then the PCM is not seeing a signal from the crankshaft postion

Ad

Question about 1999 Continental

1 Answer

...seconds of cranking? If it does not then your PCM is not seeing a signal from the crankshaft postion sensor.You can try wiggling the harness at the crankshaft postion sensor and see if it will

Ad

Question about 1997 Town Car

1 Answer

postion sensor. This sensor is located on the front passenger side of motor at the crankshaft pulley.You can disconnecting harness and clean it and reconnect it and see if it cranks. If not replace it

Question about 2000 Continental

1 Answer

...take it in to have it done unless you have a programmer. Also the throttle postion sensor may be bad or the idle air control motor needs to be replaced if it is shutting off when you put it in

...for a 98 lincoln towncar Location of this device please. I can't find it. it is on the front of the engine down low, here is a picture. how do i fix cam postion sensor on a 4.6 lincoln town ...

03 town car w/dtc p1336 had ckp/cam sensor, pugs 03 town car w/dtc p1336 had ckp/cam sensor, plugs and coil replaced still same problem Do you have a running problem or just a check engine light?

Question about 1996 Continental

1 Answer

...cam sensor and crank sensor. Both are used by the computer to determine when it is time to throw spark. If either sensor fails the car will just crank and not even try to start. If I were to guess I ...

...cam postion sensors. make sure you use Iridum spark plugs, with the gap at .051. Once I did this and replaced the cam sensors the car runs great no wench light. At 150 miles and 3 days,so far with no ...

...cam sensor and see it that takes your light on. The misfire may errase with a new cam sensor. I would hold off on the crank, until I changed the cam sensor. If it still runs rough, then maybe try the ...

Question about 2006 Navigator

1 Answer

cam sensor on bank two during startup. Have you watched the sensors with a scanner to see if they are sending a signal, or used a meter to measure current in the circuit ? Any chance the problem is in

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Lincoln LS
2000 Lincoln LS

1,383 Questions

2002 Lincoln LS
2002 Lincoln LS

1,094 Questions

2001 Lincoln LS
2001 Lincoln LS

898 Questions

Top Lincoln Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...