cam cover has to be removed and a special locking tool locks the two cams at the end. There is also another tool to lock the crank which is at the front of the engine near the gearbox, there is a bolt
cam lock bar and crank lock pin to do this job properly, otherwise you can bend some valves and that becomes expensive..the front crank damper has a mark to line up with a mark on the timing cover for
Question about 24 in. Incognito G843SCVi Built-In Dishwasher
...and pushing the cams towards the outer edge of the door based on which side it's on. Lock the cam screws clockwise once the panel is hanging squarely on the door and re-seat the plastic
i have 03 land rover freelander and the intake cam has broke at the timming gear twice now wondering if there is a common prob with this and a fix it is the v6 and its on the front bank the cams are ...
Question about BE365-PLY BE365PLY626 Satin Chrome Electronic Security Keypad Elect
cam is improperly aligned, the lock must be disassembled to a point where, with the bolt retracted, the cam can be turned to the correct position without moving the bolt. This will require withdrawing
...lock crank in correct position and cams have flat plate that goes across into both at rear of cams small section goes up from memory, the cam gears have no dowel pin/locating pin to camshaft you do ...
...cam be used to lock them. If you are looking at the cam pulleys from the RH fender side, the LH pulley hole locks at about 5 o'clock and the RH pulley at about 7 o'clock. The crank locking pin is in ...
...lock that cam pair. so are you saying you cant hold the above 4 marks aligned as you install belt (you must) or is it crank,? sparks not removed,? do so now.. why fight engine. the #1 must be firing, ...
...cam pin hold that you lock with a simple drift pin the FSM shows this fact, on all cars made. any engine. not only that you didnt say what step you got stuck? of the 50 steps. at the crank pulley,? ...
Question about 2005 407 1.8
...gears are lined up. You will need a cam lock to hold cams in correct position.. loosen locking nuts on cam gears . Use locking tool for crank shaft. Fit new belt and then torque nuts on cam
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions