...cam chain so long as the cam chain gear is timed to the crankshaft TDC marks. Pour oil over the cam and rest of the valve galley. The water pump will take care of the coolant as soon as the engine ...
Question about 2001 YZ 426 F
...cam shafts with their marks looking outwards (I think). Inlet camshaft's IN mark should look towards the rear of the bike and exhaust camshaft's EX mark should look towards the front wheel.After ...
...cam chain .Replacing the cam and cam chain is not so much the problem as lining up the cams for the timing.Any tips on how to keep cam and crank from moving while lining up the cams? can be tuff-u ...
...neither the intake nor the exhaust valves should be open. Now connect the cam chain while both the crankshaft and the cam gear are in these reference positions, and you are done! best regards, ...
...chain onto both camshaft sprockets and install the camshafts on the cylinder head.The camshafts should be installed onto the cylinder head so that the exaust cam sprocket punch mark " E " and the ...
...the other outside lines level with the head surface this is a tdc and a dead on time for a 00-03 ysf426f Align piston at top-dead-center. Then check cam and chain alignment dots to ensure
...were installed out-of-time after everything was installed including the cam chain tensioner. Note: if a valve was hitting the piston while kickstarting, it will be bent and will have to be
...exhaust. thank you the cams should face 10 and 3 with a 15 pin count on the cam chain pins from top marks on the cams the tdc mark make sure u turn it over by hand to make sure the motor is moving ...
Usually answered in minutes!
652 Questions
453 Questions
469 Questions
316 Questions
292 Questions