...tank and valve cover to gain access to the valve train. You will see both the intake and exhaust cams plus the tops of the valves. This is where you will be measuring with the feeler gauge. The ...
could you guys illustrate to us the correct timings for the camshaft of kxf25o dirt bike? We can't seem to fire up the bike hope to hear from you we are eager to fire up the bike. Thanks Set your ...
...clearance and make sure the timing is done when you are at top death center and you're exhaust cam is about to be open shortly after top death center.( that means you are in the right position
...service manual for clearances...better a little loose than too tight,can cause alot of damage to cam & head,be
250 RMZ engine torque specs. what do you need to know? head barral is 38nm and cam carriers are 10nm most 6mm nuts and bolts are 10nm. hope this helps.
2006 rmz250 When I torgue the cam bearing 2006 rmz250 When I torgue the cam bearing journals on the exhaust cam the cam turns very hard. The intake cam tightens just fine. The previous owner said it ...
...is locked up the problem is likely to be a broken retainer clip. There is a possibility that the cam chain may have broken and is wrapped up on the crank gear. Is there oil in the gearbox? The ...
...end noise, Valves are in spec ok, But did notice some metel dust on the outside end of the intake cam lobe. Can anyone tell me what i am looking at. I have a 2007 RMZ 250 with maybe 30 hours on it. ...
...winds out when you try to start it any ideeas i dont know what year is but you're problemme may cam from here this is the one way bering that may slip....you should replace them all at the same ...
...the wrong cable. If the cable is the correct one then check the positioning of the clutch release
Usually answered in minutes!
67 Questions
60 Questions
0 Questions
2 Questions