...the plastic timing belt cover and carefully remove the cover. 4) Locate the timing marks on the camshaft pulleys. I highlighted the marks with paint to make them easier to see. I took a dab of ...
...pulley should be sitting at 4 o'clock, the crank pulley should be setting at 12 o'clock, and the cam pulley should be set even with the edge of the cylinder head at about 11 o'clock. You may have ...
VOLVO 850 T5 CAMBELT SNAPPED BENT VALVES, FIXED ALL THAT NEW BELT AFTER THE HEAD WAS ASSEMBLED WITH NEW CAM BELT,CAR STARTED FINE -IDLED FOR A WHILE ,THEN CUT OUT. CHECKED SPARK, FUEL ETC. CAR WOULD ...
...problem because its doing my head in. Hi! Saft question But as your B20/23 is a safe engine the Cam/timing belt hasn't sliped a few teeth. Also make sure all relays are well seated in the base ...
...large piece (1/4 inch) can break off making a fair old leak from the oil splashing around from the cam, replace it with a NEW one, should cure ...
...SOHC Where is the heat sensor that feeds the computer on a 1989 Volvo 740GL, 4-cylinder, single cam, automatic? I've been told it should be close to the thermostat housing, but it isn't. The only ...
...both) on a 1989 Volvo 740 is located directly at the back of the engine block, connected to the cam shaft. it is the orange plastic device that the spark plug wires snap into. the rotor button is ...
i need to replace the cam front oil seal how do i get the cam gear off to replace the seal time engine up first and paint the timing marks ,then remove the belt ,rocker cover ,slacken the camshaft ...
...1991 volvo 740 Hi, this is how to align timing on a 1991 Volvo 740. There are marks for all three. Cam and Aux shafts have dots on face of outer gear. Cam lines up with mark on rear timing ...
...of the cap which concact is no 1, top or bottom if its the rear mounted distributor to the cam by firewall,looking inside cap it's the bottom contact. you can verify is point ...
Usually answered in minutes!
216 Questions
177 Questions
56 Questions
109 Questions
91 Questions