can a cam sensor cause a hard start i change my starter this week after it went bad due to a hard starting problem i had. but i was told it could be the cam sensor that cause it to go bad in the 1st ...
...a 1995 nissan maxima engine. same wat did u do to make u do the timeing az thay r not over head cam. so if u did head gasget u dont nead to do the timing. timeing how to set check the crank make ...
where is the cam position sensor located on a 2004 where is the cam position sensor located on a 2002 nissan maxima Here is
how can i tell if my 1994 nissan maxima is single or dual cam? Pretty easy to tell even without taking the valve cover off. If it is a dual cam, then the spark plugs are lined up right down the middle
...the crankshaft to TDC, (top dead center), for cylinder #1, The crank turns half the speed of the cams, so it comes up twice. You need to put it on the one for cylinder #1. Which you can verify
NOT GETTING FIRE I CHANGED THE CAM AND BOTH CRANK SENSORS CHECKED THE FUSES AND RELAYS WHATS NEXT you know that when you change the cams you have to put them marking with the timing chain silver links
Hello, Where is the Cam position sensor located on a 2004 Nissan maxima bank 1 located? 3.5litre V6 Front wheel drive, the cam position sensor is in the back of the cylinder head above the ...
how to test a cam position sensor No need, cam sensors fail on your car faster then any other car
where is a picture for a cam shaft sensor fo 2004 maxima If you have a 3.5 engine there are two cam shaft sensors(one for each cam)As you look at the engine they are at the right end of the engine,at ...
how to replace cam sensor on b1 Here's a link on removing your cam sensor. Replacing Camshaft position sensor Nissan Maxima 2004
Usually answered in minutes!
1,309 Questions
1,122 Questions
1,007 Questions
857 Questions
783 Questions