timing belt broke on mazda 5 i bought a new head but the 2 cams are not at top dead center. without belt how do i make sure that the cams are at top dead center. thanks steve Think you have to put a ...
I have a 2002 MAZDA Protege 5 with a 2.0L Engine (Twin Cam) took to the mechanic to replace the timing belt, after the replacent the engine performace went down and i can hear the engine got a little ...
where is the cam sensor on a mazda protege where is the cam sensor on a 1999 mazda protege at the end of the camshaft
...The crank pulley should have a mark that is approx 12 o clock with an arrow on the block. Both cams should have marks,'I' for the rear cam and E for the front, and the dowel pins (in the end of ...
...the belt. When the belt is reinstalled, alignment must be checked to ensure that the marks on the cam gears and crankshaft are aligned properly. Both cam gears have an "I" and an "E" mark on them. ...
replaced blown head gasket and now dont know how the lobes on the cams are supposed to face. Diagram i obtained from mazda is a little vague. Car is in time as I have done this a million times, but it
Question about 1997 Protege
...and the car cutoff, will turnover but will not crank. I can take the oil cap off and see one of the CAM's turning and turning freely My 1995 Mazda Protege 1.5L was running fine. We were driving home ...
how do i replace a cam seal on a 94 mazda protoge there is a massive oil leak on the passenger side of the motor ...
what are the timing marks for a 1.5 mazda 4 cyl engine there are two different size cam gears not possible to have two different size gears on the cams . I take it that it is a twin overhead cam to ...
how to aliane marks on cam shaft pulley on mazda protege 2002 1. Remove all spark plugs so that the crank shaft could be rotated easily. 2. Rotate the crankshaft to align the timing mark of the ...
Usually answered in minutes!
549 Questions
373 Questions
369 Questions
284 Questions
255 Questions