Tappet noise This is a common issue, Ford used this engine and we replaced the cam followers to cure the issue.
1994 mx3 1.6L DOHC ticking at the top of the engine. could the cam's be wore out or an oil gallery plugged. nay suggetions. had the same problem and my oil level was low..... filled it up and havent ...
no fire wont fire i think i need to set the cams or timing i just tightened the timing belt and now it wont fire I have the same vehicle and had the same problem. It could be one of three things. Yes ...
...well and still nothing HELP me please i have no idea whats going on VSS or vehicle speed sensor aka cam sensor or crank position sensor. Test the battery and alternator. You should also check for ...
...circulated in the HLA (hydrolic lash adjusters) that is ontop of the valves/springs under the cam. Once they are full with oil, the clicking stops and they opperate properly! Try running a ...
...but you would have to get it replaced , also check to make sure the belts are tight If this is a Cam-belt model rather than Cam-chain then probably needs cam-belt replacement - IF you've got ...
...and iac gasket but it still does the same thing Timing out by a little bit? Not a rotary is it ,cam belt or chain dont know what mx3 has being a tooth off correct position caused by tensioner ?or ...
...3 4 2 counter clockwise on distributor the timing marks are located on the crankshaft sprocket and cam shaft sprocket disconnect the negative battery terminal prier to any work preformed and pull
...mazda mx3 1.6 liter dohc im replacing my timing belt and i need to know which timing marks on the 2 cams to use Mr. RAGSDALE. I do not know if you did strip the belt yet or not. If you did not,I will ...
93 Mazda mx3 No spark. Distributor is turning. Bad coil or ignition module? Bad crank or cam sensor?
Usually answered in minutes!
138 Questions
122 Questions
88 Questions
72 Questions
6 Questions