Questions & Answers for: MAZDA6 cam

does the harmonic balancer need to be in time with the timing chain Yes the harmonic pulley has to be in the correct position. usually the pointer should be at the correct timing mark with the #1 ...

car will not start change out camshaft sen, crank car will not start, change out camshaft sen, crank sen ran for a week now will not start maybe a dicky cam sensor even if new! make sure the cam ...

mazda6 2.3 twin cam 2003,fault with cam sensor replced but fault still present any idea I suggest to check the sensor lines to ECU if all lines are good then check your timing.

diagnostic reading cam /crank... thought to be temp sensor but its ok. car does not start first time and its believed that to much fuel is being used crank and cam sensor can do that! crank gives ...

My code says Cam Sensor, I just replaced it and it's still showing the same Cam Sensor code. What can it be? Are there two? If you have a 3.0 engine in your mazda then there are two cam sensors, one ...

just completed a head o/haul,both came back with cams not installed,we dont have any specs on cam shaft timing or belt,believe has advance on rear head(could be wrong)please help 04/97 mazda eunos 800

...for mazda 6 lf 2 liter petro you need spcial tool 1 bolt pin and 1 metal line you need turn the cam shafts and from the back off the cam shaft you will see some line hol thing and when strait u ...

...friend just did this.......... Now remove valve cover check that the marks on chain line up on the cam sprockets if they don't then hate to tell you but there is a timing chain tensionor that has ...

...set timing and the timing marks? there are special tools pin to lock crank in correct position and cams have flat plate that goes across into both at rear of cams small section goes up from memory, ...

I have a 0340 code for my cam shaft I was told the diagnosis came up with a code 0340 cam shaft position Well code 340 means the cam sensor is not working correctly. The engine computer is not getting