Questions & Answers for: Jeep Liberty cam

...my Jeep Liberty 2002 I want to know where that sensor is located. Since a P0340 Could be either the Cam Position Sensor or The Crank Position Sensor they are obviously in 2 different spots, however ...

I'm replacing the timing belt on my Jeep Liberty with a 2.4L engine. The cams on top have the word ''UP'' and an arrow on both. Also, there are large marks on the gears, and smaller marks 180 degrees ...

...tools to replace timing chain as in the ford engine ,by special I mean holding tools for the cams these cams have marks but do lifters spring back or force you to hold cams in plce while ...

...and the engine died. seems like it's not getting fuel. run the fault codes and check for cam/crank position sensor ( broken timing belt) check operation of immobiliser. Check for ING fuse ...

Won't start Battery is good run fault codes and check for cam/crank position sensor. Check that the cam shaft is turning (broken timing belt) Check immobiliser operation Have a fuel pressure test done

jeep liberty 3.7l cam installation cam installation I would not recommend doing this yourself if you are not a mechanic. improper tourque sequence could crack your newcam shaft and set you back a lot ...

...http://www.wk2jeeps.com/wk2_engines.htm 3.7L Engine Firing order: 1-6-5-4-3-2 (fsm quote) why? cam or spark? its hard coded in the pcm in all cases. only coil packs matter (wired) and cam

do u have to do a cam relearn when changing cams on 2002 Jeep Liberty 3.7 No. A crank relearn is sometimes necessary, but that won't keep it from running.

...crankshaft to component in pan, not even sure what it does? no photos. so help will limited . all cam timing matters. "not sure what does", the cam, crank, sprocket or pin? The 2.4L inline 4

...time or timing chain/belt broke? WE INSPECT IT WITH MARK1, EYEBALLS (A MIL JOKE) SCAN IT YET, SEE CAM, ERRORS. >> USING REAL SCAN TOOL.? NO ENGINE TOLD 2.4l IS CAM BELT VIN DIGIT #8 IS ENGINE ...