Why does my blinker arm not return when I make a right hand turn? I am not sure if I needed to reenter the information for further advice. Here is what I asked and sent back earlier. Why does my ...
...your help. Thanks Much. Grampy55 Make sure that the choke is working and releasing the fast idle cam. May need to be lubed a little if the cam is dirty and
...CJ's had mechanical fuel pumps mounted on the side of the crank case which ran off the cam. This means that there is no pump in the tank and any fuel lines leading to that pump will be ...
...tool is available for compressing the lockplate. Remove the lockplate, directional signal canceling cam, upper bearing preload spring, and thrust washer from the steering shaft. Move the directional ...
...96 Jeep CJ7 with a manual trans and non-tilt steering. I need to replace the turn signal canceling cam as there was none installed when I purchased the vehicle last summer. I bought the one from US ...
...fuel economy increase. The 38 DGEV model is designed for higher power applications where headers, cam, and aftermarket intake manifold are used.
cam timming marks to set up the timming chain and cam timming. Should be a dimple or dot on each gear crank one points up cam one points straight down they should line up perfecly.
...a compression test. If compression is very low you can bet the chain has way too much slack or the cam gear has
Question about 1983 CJ7
timing of 4age twin cam has been set ,firing order also but it doesnt start Check for spark , fuel and compression.
Usually answered in minutes!