Questions & Answers for: kawasaki cam

Question about 1986 GPz 1000 RX

1 Answer

82 gpz 1100 cam cam orientation The cam caps are labeled 1thru 4 with an arrow toward the front. How are they positioned for reassembly? Gp 1100 1982 http://www.manualz.info/ should find the info you ...

Ad

Cam timing setup fro 1983 GPZ1100 Fuel Injection Model Hi There, I have had the cams out but can't get it to fire up, doesn't sound right, did run ok before but had to take them out due to an oil leak

Ad

Question about 1995 ZX-6R Ninja

1 Answer

cams go for timing how do the cams go in what direction do they go in for a 1995 kawasaki zx600f1 cams will only fit 1 wat. if you look at the sprocket on the can it should be stamped inlet or exhaust

...how to set the timing chain marks on a 2005 kawasaki KX250F Timing chain marks??? Or marks on your cams?? On the cams you should have 2 marks on each side of your cam sprocket. They should be even ...

...mark is located on the flywheel. you can see it through the small plug on the left side casing. cam marks, exhaust mark is on the left side of cam sprocket,lobe facing forward. inlet mark on the ...

Question about 2006 KX 450 F

1 Answer

We removed the cam and did not pay attention to timing marks. the engine was rotated without cam in it. How do we set the timing? Take the cam out and put the piston at TDC Look at the cam with the ...

Question about 1989 ZXR 400

1 Answer

my cam chain is rattley how do i tighten it ive a 89 zxr 400 There is a cam chain tensioner on the ZXR 400. It sounds like you need a new cam chain.Important Note: The cam cahin tensioner is held on ...

...is it bad or easy to fix? & how? Not super hard but you will need to be able to reset the cam timing. If you set it on TDC number one, and check the cam sprocket marks before you pull it ...

...cause when i dump the throttle i get a 1 second hesitation then the bike takes off I have power cammander full muzzy exaust and k n airfilter power curve- power ban only 2 stroke and i find its ...

Question about 1991 Zephyr 750

1 Answer

Cam timing marks Wich marks must be used to set up cam timing. Those on gears or cut-outs on end of cam. Tried all but wont start. Which mark must be used on casing what type of bike. usually there is

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...