Questions & Answers for: Jeep cam

Ad

rocker and pivot aren't worn or you may be wasting your time there. Never re-use a lifter unless it came from the exact location it had been installed in, and then, only on the same cam it was used on

Ad

...quite a bit and its to the point where it will barley pull it anymore. Heard of people putting rv cams on em? Putting a r/v cam in sometimes will help a bit. An r/v cam will not really give you

Ad

Question about 1998 Cherokee

1 Answer

How to r&r cam bearings on a 98 Jeep Cherokee(xj) with a 4.0 Since you are doing a rebuild, There is a tool made just for changing the cam bearings. If you are going into it that far, it is VERY ...

Question about 1998 Cherokee

1 Answer

cam timming marks to set up the timming chain and cam timming. Should be a dimple or dot on each gear crank one points up cam one points straight down they should line up perfecly.

Question about 1996 Grand Cherokee

1 Answer

...the expected CMP level. 1. Timing belt or chain stretched or jumped. 2. Defective CMP sensor Is the cam position sensor the same as the crank shaft position sensor? If not where is the cam position ...

Question about 1996 Grand Cherokee

1 Answer

...tools to replace timing chain as in the ford engine ,by special I mean holding tools for the cams these cams have marks but do lifters spring back or force you to hold cams in plce while ...

Question about 1997 Grand Cherokee

1 Answer

Engine light came on...reading states its my cam shaft sensor, but dealer states 1997 grand cherokees 6 cyl. dont have a cam shaft sensor...What can it be then? if reading staes its a cam shaft? Your ...

...get pressurised There are several configurations of engines; the older overhead valve conventional cam, overhead valve with overhead cam or cams utilizing chain drive, overhead cam engines with ...

Question about 1988 Wrangler

1 Answer

...guts are bad. when you turn them on the motor self runs, the runs until the keep alive contact cam reaches the end ad self turns off in park. that cam fails on all 1988, its old. and hopeless ...

Question about 2002 - Liberty

1 Answer

cam relearn 2002 Jeep Liberty 3.7 when replacing cams do u have to do a cam relearn ? Cam sensors should pick up cams you have replaced if they are the ones the manufacture recommends for the vehicle.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...