Questions & Answers for: cabriolet oil light

Question about 1990 Cabriolet

1 Answer

Oil Indicator Flashes I have a 1990 Cabriolet convertible. The alternator had stopped charging the battery so I have recently replaced the brushes. This has resolved the problem and the car is running

Ad

...oil pressure on a 1988 vw cabriolet After half hour or so of driving the oil light flashes and I also hear a buzzer along with the oil light. Its not constant I may hit the gas and it stops, but it ...

Ad

cabriolet when the engine is at an idle the oil light comes on but only flickers. When you rev the engine the oil light turns itself off. This problem only occurs after the engine has been running for

cabriolet. The oil is clean and full. Either the engine oil pump is worn, or the engine oil filter is clogged. This happened on my 1997 Cadillac Deville. After changing the oil and filter, and putting

Question about 1988 Cabriolet

1 Answer

...cabriolet, i was having the low oil pressure light coming on so i changed the oil and the light comes on again after driving the car for 20 minutes. when i rev the engine the light goes off and the ...

...cabriolet oil pressure warning light on at low rpm and idle. Oil pressure gauge shows sub 1 bar at same time. Is this a sending unit problem, or an oil pump problem? Where are sending units? Problem ...

Question about 1994 Cabriolet

1 Answer

oil light comes on under load oil sensor may be faulty or no or low oil pressure can be oil pump or low oil

Question about 1988 Cabriolet

2 Answers

Cabriolet with a cold engine, the BAR gauge shows the oil pressure pegged to the right. After the engine heats up, the oil pressure indicated drops under 2 if I am at 2000 to 2500 rpm, and the low oil

...calibrioet oil light is flashing the oil pressure is reading 150 it has shut off and wnot crank oil light flashing the oil pressure is reading 150 tha car has shut down and wont crank prob ...

...cabriolet 1.8l. Oil light comes on. I changed the hi oil pressure sensor with a new one. Tested the low pressure sensor and it passed as good. REmove the wire from the sender unit and earth on the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...