Questions & Answers for: Chevrolet Blazer cable stuck

Question about Chevrolet Blazer

2 Answers

cable pulled have them lift up on the hood and it should release. Hood is probably released but stuck, latch out of adjustment or hood support rubbers ( located on rad support) are set to high causing

Ad

...stuck down in my 1989 k5 blazer. the motor works but it doesnt move up or down. If you can hear the motor turning but window is not moving, then the window most likely came off it's track. You will ...

Ad

Question about 1988 Blazer

1 Answer

emergency brake stuck Stuck on? If so sounds like you have frozen e-brake cables. In that case you'll have to cut the cables to get the e-brake to release then replace the cables.

...but the latch under the hood wont move, its stuck? or stripped? there is a small metal cable attached to the latch inside. adjust the cable to where it is tighter and it should pop open

...stuck on. Was able to get them to stop squeeling, by going in reverse, but light is still on. Afraid may have frozen here in Omaha, NE? Sounds like a likely possibility, the reverse method definetly ...

Question about 2004 Blazer

1 Answer

stuck on any of the numbers (mph)...i heard it could be the VSS,but everything the VSS does,this is NOT doing....????? sounds like you have a bad speedometer cable - these will make the numbers 'stick

...stuck in little snow but not enough to get in the linkage. Should I jump the starter solenoid to start? I would not try to start it if it is in first gear!!! I would check the shifter level on the ...

...stuck.it is your transfer case control module.a common problem on this vehicle. try taking the positive and negitave cables off the battery and hold the two cable ends togather for a couple min then ...

Question about 2000 Blazer

2 Answers

...stuck forcing the pads against the rotor all the time then you need to replace the calipers. Don't forget to bleed the lines afterword. Regards, Tony think you didnt let the handbrake cable right ...

...reverse but doesnt work Open up the rear brakes and clean it up in there. Also check to see if your cables are binding. There might be some debris in there that prevents the cables from moving the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...