Question about Crown Audio Players & Recorders
I have a Crown Power Base 1 AMP, with a buzz. It I have a Crown Power Base 1 AMP, with a buzz. It is really loud with just the mixer hocked up and no music being put thru. I checked the mixer, and all
Can this all be hooked up? Hello. I have the following. How can I hook this up if all at possible. 2 Crown CE1000 Amps 2 Yamaha 15 pa loud speakers (non powered) 2 Jbl 15 pa loud speakers (non powered
...LITES FLASH FOR ABOUT 5 SECONDS THEN CLICKS OFF.GREEN POWER LITE IS STILL ON AND I HEAR A SLIGHT BUZZING SOUND.ANY IDEA WHAT THE PROBLEM AND IS IT WORTH FIXING. EMAIL ADD. IS [email protected]. ...
i have four xti amps in a rack ,a 2000 playing the highs 2 x 4000 playing mids at 4 ohms and a 6000 playing low mids at 2ohms Whenever i turn the 6000 on the three other amps starts to behave crazy ...
does the input signal to the xti 2002 amp make adifferance balanced or un? The balanced line input will be used for long runs to eliminate noise. it is low impedance.the high impedance line ...
distorted audio The audio level is suddenly very low and distorted, no changes in connections or use. Check the connections to the speaker(s) and make sure the connections are clean and sound first. ...
Question about XTi 2000 2-Channel Amplifier
i use the crown xti 6000 for 2 double 18s pd186 for bass per channel signal was not clear and was uneven,then one side started to clip and now i cannot here anything at all, could it be because all ...
Why doesn't right channel work? only one channel works . When I start it up it cycles lighting all lights on both channels. But after that there are no lights on the right side. No signal no clipping ...
Question about CE2000 Amplifier
Power Crown XTi 6000 activates protection and does not generate PWM what could it be? The Power Crown XTi 6000 is a power amplifier, and it sounds like it is activating its protection circuit and not ...
Usually answered in minutes!
62 Questions
68 Questions
33 Questions
21 Questions