stabilizer bar how do i install this stabilizer? Howdy, sway bar/stabilizer. disconnect neg battery cable, disable air bag (if equipped, it was an option in 91), jack up vehicle, support w/ safety ...
bushes am i able to replace the front bushes or is this something that should be done by pros i can sorce the bushes and have plenty of tools just never attempted it can i do it? u mean bushings! i ...
front suspension rattles and makes bumping noises when I drive over bumps (even small bumps) and when I turn the wheel either left or right. Possibly a ball/joint problem? It could be, but check shock
Door is to low when you close it. Are to hinges welded on you need new hing pins and bushings. easy fix. just pop out the old pin put new bushings in and put new pin in. place a jack or stand under ...
how do you replace the linkage for the manual transmission There is a shifter cable set you buy from a parts store. Get a repair manual at a book store or buy one on eBay for about 5 dollars. This is ...
How do I replace the long screw that holds the door up on the door hinges,on a '97 gmc Sonoma? I have done a 100 of these.The hardest part is going to be to reinstall the spring on the lower hinge
Question about 2001 PT Cruiser
solid bar in front end, two bushings on either side of front tires is this the sway bar? it does not effect the stering. But the bushings are broke off(Not driving). if you are talking about the sway ...
how to repair vw 2001 polo wanna change lower control arm bushes Lift Vehicle and place on axle stands. Remove wheels. Disconnect the lower control arm from the bolts that hold the ball joint, or from
Im working on a 2000 dodge dakota and cannot get the upper control arm off to replace the bushings n both nuts are removed May need a little heat (have a person stand by with water hose old rubber ...
Question about 1995 Polo 1.6
how do you remove and install lower control arm rear pivot bushings on a 1995 Acura Integra? Buy Haynes manual for car should be covered use jack stands and level ground wI'll need 2 remover bolts ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions