Questions & Answers for: Lakewood bush stand by

need help with fixing my lakewood floor fan. I have a lakewood floor fan, it use to work normal then I would have to give it a minute to warm up before the blades will spin, now its to the point that ...

engine trouble while in use, it seems that the rotor hardly turn and eventually stop clean bushing and check alignment and lubrication..

have a lakewood shop fan pedestal type with 3 blades and the switch is bad looking for diagram to replace the switch The switch has numbers on it. Mark the wires. Just connect the new switch the same ...

fan blade is not rotating but there is noise The rotor is stuck and the fan blade will not rotate then a humming noise can be heard. It is due to a bushing problem. It may be stuck due to a hardened ...

can I lay the heater on its side for storage? Can I store it in sub zero tempatures over the winter? no keep it standing up.. no not in sub zero

fan does not come on This will take some work, and some elbow grease, but what happened is the motor bushings most likely seized. Try turning the blades with your hand. If they are stiff, the bushings

how to disassemble a stand fan Hi, Plz try the link below ..hope it works if not kindly revert: https://hdsupplysolutions.com/shop/product-lakewood_18_pedestal_mount_fan-255622 Thanx

do you bypass the run capacitator on a lakewood model hv-18 fan with a 2.4 motor More than likely it's not the start capacitor why your fan will not run this more than likely it's not the start ...

Fan Blade is hard to turn Can try a little oil, if you can see the bushings on the motor Have to remove the fan, to get to the front one That will work a couple months, then it's off the the recycle ...

I have an old circular floor fan, that hums and wont come on, then suddenly it comes on? You need to clean it and oil the bushings. When this doesn't solve the problem, change the start capacitor. If ...