...wrong way. Possibly the hook that the bobbicase fits in/on has been hit by a needle and caused a burr that is catching the thread as it comes around. The burr would have to be polished off or hook ...
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
the top thread is getting knotted up where it meets the bobin. it just stops running all together. change the needle it could have a burr catching the thread
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
...You must have something threaded wrong, rethread, or your needle is the problem. It may have a burr on it and is tearing the thread, replace it. . Also, make sure your thread is the same in your ...
why does my needle keep coming unthread after use for a while Are you using bargain priced threads? They tend to have small "burrs" in them and stick at the needle's eye and snap. Have a close look at
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
...any loose threads or lint check the needle to make sure it's not bent or blunt or have a burr on it- make sure it's the correct needle for the fabric check needle plate for burrs check ...
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
thread catches in upper thread guide you might check to see if there is a burr or any damage on thethread guide
...ve put the bobbin in upside down (it's not unspooling correctly) 2. The bobbin case or bobbin has a burr. 3. it's rare but a needle plate with a burr can do this too. if you find burrs.... get some ...
thread keeps breaking change the needle rethread the machine top and bottom make sure the bobbin is wound correctly and inserted correctly make sure the are no burrs on the needle plate or in the ...
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
...stuck. If the thread is actually breaking when it penetrates the needle plate hole, there may be a burr or nick somewhere below that is catching the upper thread. You can wrap your finger with a ...
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
...problem goes away) 9.Bobbin case (replace bobbin case) 10.Machine timing. (check/adjust timing) 11.Burr in hook race, this can happen if a broken needle point jams in the race (remove burr or
Usually answered in minutes!
126 Questions
125 Questions
111 Questions
69 Questions