...bump the end of the screwdriver again. The whole handle will eventually slide backwards and fall off. Then unscrew the two screws at the front (near switch) and the front switch cover plate will lift ...
Question about SteamVac Carpet/Upholstery Deep Cleaner Vacuum
...day one but I used to be able to go further. The float pops up all the time. I thought it was from bumping the wall or furniture but now no matter how slow I go it happens all the time. Do you have
...the two components back into a position so that the front cover slides under the housing instead of bumping into it on top. I hope this solves your problem too. Thank you Systemagic. It took me a ...
Question about Floormate H3000 Upright Wet/Dry Vacuum
...bump just forward of the Brush Motor housing. Looking at the head from the bottom, the rear tab is easy to see. To see the front one, look for a small slot in the aqua plastic. Reach a small ...
Question about DC07 Animal Bagless Upright Cyclonic Vacuum
...that button is another one that turns on and off the brush!!! Good luck!!! I accidently one day bumped that button and couldn't get my brush to work but after troubleshooting it, that was my ...
...bump or do you leave the top of it above water? I'm not sure what you call the little thing that protrudes up in the middle of the tank, but that is what I'm calling a bump! I'm sure if I had the ...
Question about SteamVac F6019-900 SpinScrub Wet/Dry Vacuum
...This filled in any gaps. Then I let it sit over night to reach full strength. Align the shaft bumps with the inside of the plastic hub of the wheel. Then use a bench vice or light hammer with ...
Question about V1 SteamVac SpinScrub Vacuum
...This filled in any gaps. Then I let it sit over night to reach full strength. Align the shaft bumps with the inside of the plastic hub of the wheel. Then use a bench vice or light hammer with ...
Question about SteamVac F5914-900 SpinScrub Upright Vacuum
...This filled in any gaps. Then I let it sit over night to reach full strength. Align the shaft bumps with the inside of the plastic hub of the wheel. Then use a bench vice or light hammer with ...
Question about SteamVac F5914-900 SpinScrub Upright Vacuum
...This filled in any gaps. Then I let it sit over night to reach full strength. Align the shaft bumps with the inside of the plastic hub of the wheel. Then use a bench vice or light hammer with ...
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions
