Questions & Answers for: Harley Davidson FXDBI Street Bob bump top

Fork oil What is the correct quantity of oil for the fork tube and what is the level measurement from the top of the tube? hi ya poor the oil in with the forks compresed right down . poor oil in until

I want to make a part I have a 2006 Dyna street bob efi and I want to make my own passenger footpeg support brackets. I would be real greatfull if someone that had them could give me a detailed ...

clunking noise in front end of harley when going over bumps sounds like shocks in front end bottoming out would guess that they are not bottoming out, they are topping out. doubt that you get them to ...

how to install torque cones on a harley Take your exhaust pipes loose and drop the cone into the pipe. It has a lip that catch on the top of the pipe. Then, bolt the pipe back up.

inside slider tube on 2007 49 mm showa front forks there is a teflon looking bushing or stop, I can not see how to remove it, want to do a performance coating on slider an it will be subjected to 350 ...

how to replace shock absorber on a 1200 Sportster 2007 Simply remove the nut from the top stud and the bolt at the bottom and remove the shock absorber. Now, if you're talking about replace the shock ...

Speedometer on 2005 sportster not working. Hi Anonymous, always check your instrument fuse before performing the next procedure, try cleaning your speed sensor located on top of the transmissions ...

change fork oil street bob 2007 To change the oil or to rebuild a 2007 DYNA front fork FIRST raise and support the motorcycle so that the front end is off the floor and the forks are fully extended, ...

replacing fuel sender unit on a 2008 street bob gauge only reads to the top of the low mark when tank is full, it goes all the way down when key is turned off Determine if it is the fuel sender that ...

how to replace a gas tank fuel float Remove console, disconnect electrical connectors, remove vent hose, remove and discard screws and washers and open fuel tank top to access and remove fuel pump and