...top of the connector has rusted out and the bolts are lose so every time i hit a bump i hear the clunking noise. easy way to check for this is to go over a speed bump at a angel where one tire goes ...
...than coming to a hard stop. The ABS engages, the brake pedal stays at the top, there is a lot of bumping and feedback and the truck doesn't want to stop. I have replaced the front brake pads, but ...
...bump the starter and watch for top dead center on harmonic balance,to come around,you should feel suction right before it gets to top dead center,Then stop,and turn the balance more until it gets to ...
...bump vehicle stalled now only cranks has a high smell of fuel but no spark You need to reset the fuel pump cut off switch. It turns the pump off when in accident, so gas doesn't keep pumping. It is ...
top of intake manifold to the front right behind the throttle body it sticks up and is plastic and one good bump it breaks. Not a easy part to purchase. Mine broke cause i slipped and put my hand down
...looking at front of engine 1,3,5,and 7 are on right,2,4,6,8 on left. You must crank engine by bumping starter with finger over no. 1 plug hole until compression stroke is felt. Look at timing ...
top of the blower motor housing. Do you not have any voltage at the purple wire that plugs into the blower motor? That voltage will come from the relay. If one of the resistors is burnt into, you will
Question about 2003 Yukon XL
...top and line up timing mark , Ifind it easy to put thumb over spark plug hole and have someone bump the engine over and feel the pressure relief stop before you feel vacumm - timing mark should line ...
...bump key slowly while you put your finger where the plug goes...you will feel pressure push against your finger...when the pressure stops, your No. 1 piston is at top dead center, your rotor will be ...
Question about 2005 Sierra
...bump turns off. Do you have a air bag light on the dash ? Check ground circuit for lose connection . Ground G203 In the I/P harness, on the left side of the I/P near the A-pillar below the I/P top ...
Usually answered in minutes!
2,225 Questions
1,363 Questions
1,368 Questions
1,418 Questions
1,123 Questions