Questions & Answers for: Oldsmobile Alero btsi solenoid

Question about 1999 Alero

1 Answer

1999 oldsmobile Alero Door Lock My passenger door lock does not operate under the electronic system. I have to manually lock and open the door. I guess the electronics need replacing. What is the ...

Ad

...Make sure your brake light switch is working,2nd there is a BTSI solenoid (brake transmission shift interlock) that could be bad. Where is the brake transmission shift interlock located? ...

Ad

Question about 1999 Alero

1 Answer

evap solenoid EVAP SOLENOID LOCATION ON THE 2.4L ENGINE IS MOUNTED ON BRACKET NEAR THE AIR CONDITIONER COMPRESSOR.FOR THE 3.1L AND THE 3.4L ENGINES THE EVAP SOLENOID LOCATION IS AT THE REAR FIREWALL ...

2000 Oldsmobile Alero 3.4L Secondary air pump system. have pump connected and in working order on start up. possible relay malfunction and/or vacuum valve solenoid maybe faulty. system is reading ...

Question about 2001 Alero

1 Answer

need to know how to change tranmission shift sensor? Shift Solenoid maybe? Usually in the pan area. This requires dropping the tranny pan underneath and changing the fluid, filter, gasket, and ...

getting computer code p1665 fuel level output circuit. Fuel gauge appears to be shorting out because it is always reading full CODE P1665 - EVAP VENT SOLENOID CONTROL CIRCUIT MALFUNCTION ...

Question about 1999 Alero

1 Answer

putting starter back on vechicle need help with wiring LOOKING AT STARTER WIRES.BATTERY CABLE POSITIVE CABLE GOES TO STARTER SOLENOID POSITIVE POST TERMINAL THAT IS THE LARGE STUD IN THE STARTER ...

Question about 2001 Alero

2 Answers

when you try to start the car the starter will first click then if you hit the key again it will turn slowly then whirl then finally start i think its bad spot in the starter but not sure? Bad Starter

Question about 2002 Alero

2 Answers

Gm Code P0741 If the PCM detects high converter slip when the TCC is commanded on, then a DTC P0741 will set. The following conditions must exist for two times during the same ignition cycle. This ...

is the p0758 code and internal transmission problem? the code reads p0758 circuit electrical and another one reads p0758pd circuit electrical It could be a bad solenoid, the wiring harness in the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...