Question about Lift-Off(R) Revolution(R) Turbo Upright Vacuum
...catch when turning by hand. Could this be enough to cause the brush motor axle to burn through a new belt in less than a minute? Can you take the brush unit apart to clean, or just find a
6 rotating brushes What causes the 6 rotating brushes to not work? I take the 6 brush strip offand turn the rod for the brushes and they turn. It's when I put the 6 rotating brushes back on the ...
Question about DC14 Animal Bagless Upright Cyclonic Vacuum
...turning. The brush bar on my dyson animal control stopped turning. I was starting the vacuuming and the bar stopped turning. I cleaned off any strings before I started vacuuming too. I turned the ...
Question about SteamVac F5914-900 SpinScrub Upright Vacuum
agitator brushes wont turn even after cleaning hoover steamvac f5914-900 agitator brushes wont turn even after cleaning filter. the brushes will not turn even wen the switch is turned on the gear that
Question about 9500 ProHeat 2X CleanShot Upright Deep Cleaner, Red Berends Vacuum
The brushes do not turn when the unit is on. What do I do? The belts appear to be fine, Is there an internal fuse? check belt if ok .may be brushes motor bad.... Unplug power before trying this test !
Beater brush my beater brush will not move check for anything in the brush just bought the vaccum 30 days ago Note: The brush will not rotate when the machine is locked in the upright position, ...
Question about 3576 CleanView II Bagless Upright Vacuum
I put a new belt on my vacuum and right away it broke There may be a problem with the brush roller itself. When the belt is removed and you have the brush in your hand, make sure that you can turn it.
Question about 3576 CleanView II Bagless Upright Vacuum
replacing brushes on makita hr2470t percusion drill having trouble replacing brushes Turn the brush ring anti clockwise so the top brush is to the right as you look at it. lift the spring out the way ...
Question about SteamVac F5914-900 SpinScrub Upright Vacuum
brush block assembly. Try turning that drive shaft connected to the middle brush. All the brushes should be able to do a full turn simultaneously. If the brushes get stuck and cant make a full turn or
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions