Questions & Answers for: brush turn

brush does not turn, keeps burning the belts in half. Brush motor works fine. Brush itself seems to be the problem. Seems to have a slight catch when turning by hand. Could this be enough to cause the

...brush strip turn at all? If so, when you install the brush strip see if the will turn when no pressure is applied to the brushes (tilt the Vac back). If none of this works, then the switch that ...

...brush bar section and the bar will turn when I rotate it, the belt seems to be intact. If this model has a brush control - i.e a roller at the side of the model which controls brush to spin or not, ...

agitator brushes wont turn even after cleaning hoover steamvac f5914-900 agitator brushes wont turn even after cleaning filter. the brushes will not turn even wen the switch is turned on the gear that

turn too. Alot of time there is build up around the brush shaft, hair & / or rug remnants. you may have to remove the brush in order to remove the debris. Sometimes there maybe something lodged in

...and the brush shuts off, turn off the vacuum and unplug this from the outlet. You can now remove the obstruction. The brush will automatically reset when the vacuum is plugged in and turned back

...turn the brush with your fingers. The brush should turn. If not, and I have done this myself before too, the belt may have been caught under the brush and not able to turn at that point. When you get ...

...Turn the brush ring anti clockwise so the top brush is to the right as you look at it. lift the spring out the way and hook it to the side of the brush holder. you can then remove and replace the top ...

...brush. All the brushes should be able to do a full turn simultaneously. If the brushes get stuck and cant make a full turn or if all of the brushes aren't spinning together then your brush block will ...