Questions & Answers for: iRobot brush motor

...brush drive line. right off the motor is a gearbox, held on with two screws. getting to it is fairly complicated, fix is easy. parts can be found at Protech Robotics Parts and Service Run the Roomba ...

...motor that turns the brush is shot. there is no replacement part. they offered to replace my i-robot with a new one from the 400 series. at about 60% of a new one. that's the only option that i know ...

could be an issue with the gears being stripped in the brush motor assembly or inside the brush compartment holder. If the gears are fine the brush motor itself may be blown. A new one is about $30.00

...brush motor has gone bad. Check first to make sure that the motor isn't just bound up with hair or something. Fortunately, it's easy to replace and relatively inexpensive.. See this video link on ...

...brush motor--the unit will think that something is wrapped around the brush and slowing down the motor. if you have cleaned your brush and are sure that is not the problem; you need to look for ...

brush stops when it hits carpet. motor prob's? fix? Remove and clean the yellow bearing on each brush, then reinstall them. Run the Roomba and ensure that the brushes do turn on hardwood, then test it

...brush drive assembly. If its under warranty replace the assembly. If the warranty has expired and you have the skill, you can remove the assembly and vacuum it aroundthe motor. Next remove the screws ...

...brush? both? How did you find that they are not spinning? To properly test, place the front wheel on the table edge and hold the wheels up in the machine (dont hold the tires) , Then start the clean ...

...Head Assembly and the other end that connects to the brush motor may also suffer From the same condition. Here are some of my photos to reference ...

...brush unit. There are several videos/guides online that will show you haw to dissassemble the gears, clean out the gunk, and reassemble. Basically there are four screws that hold the unit in; once it ...